![]() When your Mac restarts, it will automatically boot from macOS Installer to continue the installation. Here it ends the first phase of the installation. Your Mac will restart to complete the installation. Upon completion, the system will automatically restart. This will take a couple of minutes and will restart at "Less than a minute is remaining".Simply click on Restart to restart your Mac After clicking on Reboot, you'll see the confirmation dialogue box to restart your Mac. Once, you're done with all the above processes, click on Reboot.Ģ0. Once OCLP finishes installing OpenCore to the target disk, you'll see the following.Īnd within a few seconds, it will prompt to reboot.ġ9. When prompted, enter your system passwordġ8. From the available FAT32 (ESP) Partition, select the disk to install OpenCore. Select the Bootable USB you prepared in Step #3. When prompted, click on OK to allow disk access.ġ6. Click on Install to disk and you should have something similar to the screenshot attached below. Once the OpenCore is built, it will prompt you to view the log and install OpenCore to the target disk for booting.ġ5. Click on Build and Install OpenCore and then click on Build OpenCore buttonġ4. ![]() Click on Return Settings and you should have something similar to the screenshot attached below.ġ3. The SMBIOS should be similar to the screenshot attached below.ġ1. Click on Generate S/N and it will generate a Serial Number. Do not select a different Platform, i.e For MacBookPro, select the ideal MacBookPro Spoof Model.ġ0. Select the Spoof Model, depending on your Mac model.The Spoof Model should be natively supported with macOS Ventura.As I'm using Macmini7,1, it would be best to select Macmini8,1 which is natively supported with macOS Ventura. ![]() Select Advanced in SMBIOS Spoof Level and then select the SMBIOS Spoof Model. Click on SMBIOS Settings and you'll see something similar to the screenshot attached below.ĩ. If you're using a Mac which is Monterey compatible (natively), select Allow native models checkbox.Ĩ. To select the target Mac model, simply click on con Settings and select the target Mac model identifier from the drop-down selection.ħ. However, it is still recommended to select the target Mac model identifier from the drop-down selection, especially if you're running OCLP from any other than the target Mac. OCLP detects the Mac model automatically. It is strongly recommended that you use the target Mac to Build OpenCore as for a few Macs (Monterey Capable), the tool doesn't give the option.Ħ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |